How the putty pad works

Electrical outlets are "holes" in your wall that act like direct tunnels for noise. Even a soundproofed wall will fail if the sockets aren't treated. This pad wraps the back of the box to seal the leak.

1. High-Mass Intumescent Material: The dense putty adds critical mass to thin plastic or metal outlet boxes, reflecting sound back instead of letting it pass through.

2. Acoustic Sealing It creates an airtight gasket around wires and box edges, stopping the "flanking" noise that bypasses your insulation.

3. Fire Retardant works on any standard interior door, hollow-core or solid, single-side or both sides.

Result: Restores the sound-blocking integrity of your wall (STC rating) in under 5 minutes.

What the numbers mean

STC Improvement +5 to +10 — Restores the wall's performance to its original rating by sealing the most common "weak link" in room construction.

UL 263 Classified — Tested to maintain the fire resistance of wall assemblies for up to 2 hours.

Honest note: utty pads are essential for wall soundproofing but work best when used on both sides of a shared wall (back-to-back outlets) and paired with wall insulation.

What's in the box

• 12 , 24 or 48 Putty Pads . Each panel is 15x20x0.3cm (6 x 8 x 0.12in)
• Pre-applied self-adhesive backing on every panel
• Step-by-step install guide

Simple 4-Step Installation

1. Remove: Take off the outlet faceplate (ensure power is off if touching wires).
2. Peel: Remove the protective paper from the putty pad.
3. Mold: Wrap the pad firmly around the back and sides of the electrical box.
4. Seal: Press the edges to create an airtight bond against the drywall, then replace the faceplate.

No drill. No nails. No contractor.

Made for

Electrical outlet boxes  ·  Light switch boxes  ·  Junction boxes  ·  Metal and plastic electrical boxes  ·  Home theaters  ·  Offices  ·  Apartments ·  Recording studios  ·  Commercial buildings

Frequently asked questions