EZ-REPAIR PLASTIC/BUMPER 1 MINUTE 1:1 220ml

EZ REPAIR 1 minute #055395-99400 Two-part urethane (1:1) used for structural and cosmetic repairs of all plastic bumpers including TPE, TPO, TEO, PP and ABS and can be used to bond SMC or fiberglass panels. • One product for all structural and cosmetic repairs on bumpers • Easy to sand • Will not lift or roll up • No plastic identification required with

Times will increase as temperatures decrease. Times shown above are at 70°F/21°C. Full cure time is 24 hours but this may be accelerated with heat. EZ REPAIR adhesives SHOULD NOT be used for bonding structural components such as rails, pillars, rocker panels, core supports, etc. If in doubt as to what is a structural component, contact the vehicle manufacturer

DO NOT APPLY POLYESTER BASED FILLERS (POLYESTER PUTTY/FILLER) TO ANY URETHANE EZ REPAIR ADHESIVE. IF POLYESTER BASED FILLER MUST BE USED, THE URETHANE EZ REPAIR MUST BE SEALED WITH ONE OF THE FOLLOWING: PRIMER (EITHER 2 PART EPOXY OR 2 PART URETHANE OR SKIM COAT OVER THE EZ REPAIR REPAIR AREA USING EZ REPAIR SKIM COAT EPOXY REPAIR/FILLER ADHESIVE #99403).

Applications: Repairs bumper tabs, trim, and small plastic parts. Bonds plastic parts to plastic and coated metals. Repairs tears and holes on bumpers, trim, moldings, etc.