Note: All NEO65 Units are only available in Tri-mode PCB, plate type will be stated in options

Specs

• Typing angle：8 degree
• Front height：17mm
• Size：310.35mm * 107.8mm
• Weight：
  • Before build：0.97kg
  • After build：1.32KG
• PCB Specs
  • 1.6mm
  • All PCBs are QMK-based, VIA supported
  • Three PCB options:
    • Tri-mode Hotswap
      • Support wired, Bluetooth, and 2.4GHz connection
      • Support both ANSI and ISO layout
      • NKRO
      • Polling rate: 1000Hz in wired and 2.4Ghz mode; 125Hz in BT mode
        

Firmware & Resources (Click Here)

Package Contents

• Case
  • Including selected weight pre-installed
  • Two pre-installed 2200mAh batteries for Tri-Mode PCBs
  • Fillers for battery compartment for Wired PCBs
• PCB Kit
  • PCB of your choice
  • PE Sheet
  • PCB Foam
  • Standoffs
  • 2.4GHz dongle for Tri Mode PCB
• Plate 
• Poron Case Foam
• Daughterboard and Cable
• Silicone Gaskets
• O-Ring (50 Duro)
• Rubber Feet in Grey and Black
• Weight Screws in Silver and Black
• Free Gifts (Not covered if damaged or missing)
  • Carrying Case
  • Hex Screwdriver
  • Phillips Screwdriver
  • Keycap and Switch Puller
  • 1 Set of 65% PCB Clip-in NeoStabs
  • USB-C Cable

Further notes and instructions:

1. Oxidation of brass and copper weights is unavoidable due to the characteristics of these materials. If you are concerned about this, please choose the PVD stainless steel weight instead.
   
   
2. Chroma and Dusk are random mixes of gradients, so the result on each unit may vary.
   
   
3. The tri-mode PCB on this sale page comes with a pair of 2200mAh batteries
   
   
4. All PCBs are QMK-based and support VIA.