This luxury half-moon wall mirror features a sleek, modern design with a polished frame, adding elegance and sophistication to any space. Its curved shape creates a striking visual appeal, perfect for enhancing both contemporary and classic interiors.

• 6mm thick
• Silver Pilkington Optimirror
• Polished edges all round
  
• One tube of glue supplied

Bespoke sizes available on request please feel free to contact us to discuss further.

Please note: We can only deliver this product to a UK mainland address and to a ground floor only.

Mirror Fitting Instructions - Adhesive

Important Information

These instructions are for installing a single mirror using adhesive only.
Our recommended mirror adhesive is supplied with your order and must be used as directed for safe and long-lasting installation.

Mirror Backing Check

• Do not apply adhesive to safety-backed mirrors.
  Safety backing is a white or clear plastic film applied to the back of some mirrors for shatter resistance.

• Foil-backed mirrors (metallic in appearance) are suitable for adhesive fitting.
  Foil backing protects the mirror from adhesive damage and is safe to use.

Warning: Using the wrong adhesive or applying it to a safety-backed mirror may cause the glue to degrade the paint and silver backing over time.

Tools & Materials Required

• Tape measure
• Pencil
• Mastic gun
• Supplied mirror adhesive
• Stanley blade (for cutting nozzle)
• Glass suckers (optional, for easier lifting)
• Baton or temporary support (recommended for mirrors over 15kg)
• Low modulus neutral cure silicone (for sealing in wet areas)

Support Baton (Recommended for Heavy Mirrors)

• For mirrors over 15kg, we strongly recommend installing a temporary baton or ledge at the bottom to support the mirror while the adhesive cures.

• This prevents slippage during the drying process.

• A piece of skirting board or timber offcut works well. Ensure it's level and secure.

Surface Preparation

• Make sure the wall surface is clean, dry, and dust-free.

• Lightly mark the desired mirror position using a pencil and tape measure.

Adhesive Application

1. Lay the mirror on a soft, flat surface with the painted backing facing up.

2. Cut the nozzle of the adhesive tube with a Stanley blade and load it into a mastic gun.

3. Apply horizontal lines of adhesive approximately 10cm apart across the back.

4. Avoid applying adhesive too close to the edges to prevent squeeze-out when mounting.

Mounting the Mirror

1. Carefully lift the mirror (use glass suckers if needed) and position it on the wall.

2. If using a baton, gently rest the mirror on it for support.

3. Press the mirror firmly into place and hold it for at least 3 minutes.

4. The adhesive sets gradually—do not disturb the mirror while it cures.

Curing Time

• Allow the adhesive to fully cure for 24 hours before removing any supports or applying pressure.

• Ensure the room is at a stable ambient temperature to promote proper drying.

Sealing (Optional – For Wet Areas)

• For mirrors installed in bathrooms, kitchens, or other moisture-prone areas, we recommend sealing the edges.

• Apply a thin bead of low modulus neutral cure silicone around the back edge to protect the mirror from water and cleaning products.

• Our sealant is clear, but coloured versions are available if preferred.