Does this bumper have pre-cut fog light openings or sensor holes?

This is a solid panel — no factory cutouts. If your build requires fog lights or sensor integration, reference your OEM bumper hole locations and mark them on the FRP before cutting. This gives you full control over placement and diameter to match your setup exactly.

Will this fit my lower valance and splitter combo?

This bumper is a direct replacement cover for the front fascia. Compatibility with aftermarket valances and splitters depends on your specific parts' mounting points and clearance geometry. Before ordering, confirm your existing lower bodywork will align with a new bumper panel at the top edge.

What prep work is needed before painting?

Sand the surface with appropriate grit to scuff the gelcoat, then clean away all dust and residue. This ensures your topcoat adheres properly. Work with your chosen paint system — primer type and paint selection vary by shop preference and finish goals.